NumloomCalculation setup — values are entered in Runner.Preview

Cabinet edge banding by unit count

Use one length unit for both the measured banding per cabinet or door and the result. Enter the allowance per item and a waste multiplier; the starting numbers are editable examples. Enter the item count in Numloom. No length conversion is performed.

Calculations currently require access to Numloom on Google Play Internal Testing. iPhone and iPad support is planned.

Open this calculation on your phone

Scan with an Android camera. If Numloom is installed, the HTTPS link opens the calculation in Runner. Installation currently requires access to the Google Play internal test. After installation, launch Numloom normally; if the calculation is not restored, open this link again.

Enable JavaScript to check this link.

1Parameters

Editable starting values, not standards or manufacturer recommendations. Check the values for your material or equipment.

How it works

Edge banding length in the same unit as the allowance per item = Number of cabinets or doors × Edge banding length per item × Waste multiplier

In Numloom: “Number of cabinets or doors” → “Edge banding length in the same unit as the allowance per item”.

items → your length unit

Edge banding length per item · same length unit/item
Waste multiplier · 1

This page shows the formula and parameters. The calculation runs in Numloom.

Assumptions and limits

Calculation basis: “Number of cabinets or doors” (items) → “Edge banding length in the same unit as the allowance per item” (your length unit). Use the parameters shown for this particular operation.

Measure the required edge length for one cabinet or door. Item count alone cannot determine the geometry, and this result is not a complete hardware list.

Enter a non-negative value in the app.

Coefficient sources

Initial settings: Edge banding length per item = 1 same length unit/item (demonstration value); Waste multiplier = 1.05 1 (demonstration value).

These starting values are not a standard, calibration certificate or manufacturer recommendation. Replace them with values measured for your process or specified for your product.

Related calculations · Preview

Calculations currently require access to Numloom on Google Play Internal Testing. iPhone and iPad support is planned.

Open this calculation on your phone

Scan with an Android camera. If Numloom is installed, the HTTPS link opens the calculation in Runner. Installation currently requires access to the Google Play internal test. After installation, launch Numloom normally; if the calculation is not restored, open this link again.

Enable JavaScript to check this link.