NumloomCalculation setup — values are entered in Runner.Preview

Dough weight by number of pieces

Set these parameters: “Mass per piece”. In Numloom, enter “Number of dough pieces” (items) to obtain “Dough mass” (g).

Calculations currently require access to Numloom on Google Play Internal Testing. iPhone and iPad support is planned.

Open this calculation on your phone

Scan with an Android camera. If Numloom is installed, the HTTPS link opens the calculation in Runner. Installation currently requires access to the Google Play internal test. After installation, launch Numloom normally; if the calculation is not restored, open this link again.

Enable JavaScript to check this link.

1Parameters

Editable starting values, not standards or manufacturer recommendations. Check the values for your material or equipment.

How it works

Dough mass = Number of dough pieces × Mass per piece

In Numloom: “Number of dough pieces” → “Dough mass”.

items → g

Mass per piece · g/item

This page shows the formula and parameters. The calculation runs in Numloom.

Assumptions and limits

Calculation basis: “Number of dough pieces” (items) → “Dough mass” (g). Use the parameters shown for this particular operation.

Keep the stated raw or finished weight basis and the same serving size. Use the relevant recipe or portion specification; no nutritional allowance is prescribed here.

Enter a whole number of the items counted.

Coefficient sources

Initial settings: Mass per piece = 60 g/item (example in the original task description).

These starting values are not a standard, calibration certificate or manufacturer recommendation. Replace them with values measured for your process or specified for your product.

Related calculations · Preview

Calculations currently require access to Numloom on Google Play Internal Testing. iPhone and iPad support is planned.

Open this calculation on your phone

Scan with an Android camera. If Numloom is installed, the HTTPS link opens the calculation in Runner. Installation currently requires access to the Google Play internal test. After installation, launch Numloom normally; if the calculation is not restored, open this link again.

Enable JavaScript to check this link.