NumloomCalculation setup — values are entered in Runner.Preview

Glaze recipe percentages to ingredient weight

Set these parameters: “Percentage share”. In Numloom, enter “Total glaze batch mass” (g) to obtain “Mass of one recipe component” (g).

Calculations currently require access to Numloom on Google Play Internal Testing. iPhone and iPad support is planned.

Open this calculation on your phone

Scan with an Android camera. If Numloom is installed, the HTTPS link opens the calculation in Runner. Installation currently requires access to the Google Play internal test. After installation, launch Numloom normally; if the calculation is not restored, open this link again.

Enable JavaScript to check this link.

1Parameters

Editable starting values, not standards or manufacturer recommendations. Check the values for your material or equipment.

How it works

Mass of one recipe component = Total glaze batch mass × Percentage share ÷ 100

In Numloom: “Total glaze batch mass” → “Mass of one recipe component”.

g → g

Percentage share · %

This page shows the formula and parameters. The calculation runs in Numloom.

Assumptions and limits

Calculation basis: “Total glaze batch mass” (g) → “Mass of one recipe component” (g). Use the parameters shown for this particular operation.

The result is one ingredient. A share of the base recipe and an addition on top of that base have different denominators; this does not generate a complete glaze recipe.

Enter a non-negative value in the app.

Coefficient sources

Initial settings: Percentage share = 40 % (demonstration value).

These starting values are not a standard, calibration certificate or manufacturer recommendation. Replace them with values measured for your process or specified for your product.

Related calculations · PreviewAmount of one glaze colorant or additiveWet clay size from finished dimensionsFired clay size from wet dimensions

Calculations currently require access to Numloom on Google Play Internal Testing. iPhone and iPad support is planned.

Open this calculation on your phone

Scan with an Android camera. If Numloom is installed, the HTTPS link opens the calculation in Runner. Installation currently requires access to the Google Play internal test. After installation, launch Numloom normally; if the calculation is not restored, open this link again.

Enable JavaScript to check this link.