NumloomCalculation setup — values are entered in Runner.Preview

Laser cutting batch time

Set these parameters: “Processing time per item”. In Numloom, enter “Number of pieces to cut” (items) to obtain “Cutting time” (min).

Calculations currently require access to Numloom on Google Play Internal Testing. iPhone and iPad support is planned.

Open this calculation on your phone

Scan with an Android camera. If Numloom is installed, the HTTPS link opens the calculation in Runner. Installation currently requires access to the Google Play internal test. After installation, launch Numloom normally; if the calculation is not restored, open this link again.

Enable JavaScript to check this link.

1Parameters

Editable starting values, not standards or manufacturer recommendations. Check the values for your material or equipment.

How it works

Cutting time = Number of pieces to cut × Processing time per item ÷ 60

In Numloom: “Number of pieces to cut” → “Cutting time”.

items → min

Processing time per item · s/item

This page shows the formula and parameters. The calculation runs in Numloom.

Assumptions and limits

Calculation basis: “Number of pieces to cut” (items) → “Cutting time” (min). Use the parameters shown for this particular operation.

The estimate assumes the stated operation has a constant time or rate per item. Machine time and person-hours differ; setup, downtime and parallel work require their own measured allowance.

Enter a whole number of the items counted.

Coefficient sources

Initial settings: Processing time per item = 30 s/item (demonstration value).

These starting values are not a standard, calibration certificate or manufacturer recommendation. Replace them with values measured for your process or specified for your product.

Related calculations · PreviewLaser engraving batch timeCNC machining time for a batchProduction time from quantity and rate

Calculations currently require access to Numloom on Google Play Internal Testing. iPhone and iPad support is planned.

Open this calculation on your phone

Scan with an Android camera. If Numloom is installed, the HTTPS link opens the calculation in Runner. Installation currently requires access to the Google Play internal test. After installation, launch Numloom normally; if the calculation is not restored, open this link again.

Enable JavaScript to check this link.