NumloomCalculation setup — values are entered in Runner.Preview

DTF ink consumption by transfer count

Set these parameters: “Volume per piece”. In Numloom, enter “Number of transfers” (items) to obtain “Ink volume” (mL).

Calculations currently require access to Numloom on Google Play Internal Testing. iPhone and iPad support is planned.

Open this calculation on your phone

Scan with an Android camera. If Numloom is installed, the HTTPS link opens the calculation in Runner. Installation currently requires access to the Google Play internal test. After installation, launch Numloom normally; if the calculation is not restored, open this link again.

Enable JavaScript to check this link.

1Parameters

Editable starting values, not standards or manufacturer recommendations. Check the values for your material or equipment.

How it works

Ink volume = Number of transfers × Volume per piece

In Numloom: “Number of transfers” → “Ink volume”.

items → mL

Volume per piece · mL/item

This page shows the formula and parameters. The calculation runs in Numloom.

Assumptions and limits

Calculation basis: “Number of transfers” (items) → “Ink volume” (mL). Use the parameters shown for this particular operation.

Measure consumption for this design and printing process. Allowance and fixed reserve are separate; a coefficient for ink does not describe powder or film.

Enter a whole number of the items counted.

Coefficient sources

Initial settings: Volume per piece = 2 mL/item (demonstration value).

These starting values are not a standard, calibration certificate or manufacturer recommendation. Replace them with values measured for your process or specified for your product.

Related calculations · PreviewDTF powder consumption by transfer countDTF film length by transfer count

Calculations currently require access to Numloom on Google Play Internal Testing. iPhone and iPad support is planned.

Open this calculation on your phone

Scan with an Android camera. If Numloom is installed, the HTTPS link opens the calculation in Runner. Installation currently requires access to the Google Play internal test. After installation, launch Numloom normally; if the calculation is not restored, open this link again.

Enable JavaScript to check this link.