NumloomCalculation setup — values are entered in Runner.Preview

Embroidery thread length by piece count

Set these parameters: “Length per piece”. In Numloom, enter “Number of embroidered pieces” (items) to obtain “Thread length” (m).

Calculations currently require access to Numloom on Google Play Internal Testing. iPhone and iPad support is planned.

Open this calculation on your phone

Scan with an Android camera. If Numloom is installed, the HTTPS link opens the calculation in Runner. Installation currently requires access to the Google Play internal test. After installation, launch Numloom normally; if the calculation is not restored, open this link again.

Enable JavaScript to check this link.

1Parameters

Editable starting values, not standards or manufacturer recommendations. Check the values for your material or equipment.

How it works

Thread length = Number of embroidered pieces × Length per piece

In Numloom: “Number of embroidered pieces” → “Thread length”.

items → m

Length per piece · m/item

This page shows the formula and parameters. The calculation runs in Numloom.

Assumptions and limits

Calculation basis: “Number of embroidered pieces” (items) → “Thread length” (m). Use the parameters shown for this particular operation.

Use thread consumption measured for this stitch pattern or finished item. Stitch count and item count are different bases, and sewing consumption is not an embroidery standard.

Enter a whole number of the items counted.

Coefficient sources

Initial settings: Length per piece = 2 m/item (demonstration value).

These starting values are not a standard, calibration certificate or manufacturer recommendation. Replace them with values measured for your process or specified for your product.

Related calculations · PreviewEmbroidery thread length by stitch count

Calculations currently require access to Numloom on Google Play Internal Testing. iPhone and iPad support is planned.

Open this calculation on your phone

Scan with an Android camera. If Numloom is installed, the HTTPS link opens the calculation in Runner. Installation currently requires access to the Google Play internal test. After installation, launch Numloom normally; if the calculation is not restored, open this link again.

Enable JavaScript to check this link.